If it doesn't drain out, add fluid through the plug hole until the fluid … is level with the bottom of the plug. This information is completely wrong!. Inspect the fluid pump support for damage. If fluid drains out, the level is full. You don't have to change the automatic transmission fluid on your Ford Explorers if you drive it under normal driving conditions, but regular changes will extend the life of the transmission. Earlier models, pre 2002, had a dipstick and you could check fluid levels and top-up the fluid.
With the vehicle running at normal operating temperature. I changed the filter and put a new filter in. Wipe the stick with a rag or paper towel, then place it back into the holder. Jan 05, 2011 How many miles? Do this by wiping the dipstick with clean a white paper towel and examining the fluid on the paper. If fluid pours out when you remove it, that means the transmission is full.
When adding transmission fluid to your Explorer, be sure to add it slowly as it will fill up quickly and is difficult to remove excess fluid if you overfill. Chevy cobalts auto or standard don't have a dipstick there is a plug under the car near the torqe converter u must have the car running and up to normal running temp raise the car evenly on all sides so its level while its running crawl under undo the plug if fluid runs out its full if not go to the top of the car near the fuse block undo the vent cap at the top of the tranny big black cap and fill there until fluid drips out of the hole by the torqe converter when it drips put plug back in and vent cap and you are done i am a mechanic at a local chev dealer and own one Answer. Was just checking to see in your opinion what it could be? Continue this until the fluid is up to the full line. To submit your questions or ideas, or to simply learn more, see our about us page: link below. Mercon R Automatic Transmission Fluid or equivalent. Look at the left side of the motor, walk around and stand on the left, passenger's side of the car.
Just for your Information, the Ford Explorer 2004 Do not have a dip stick, it has to be inspected by a certified mechanic or respective cerfied auto repair shop. Pull the dipstick out and wipe it clean with a paper towel or a rag. Consult the ownerï¿½s manual for this information. I got a ford taurus that was said to have a bad trans. If transmission lubricant is suspected of overheating.
It's possible that you have the same or very similar concern. Manual transmissions, on the other hand, can accept a variety of fluids, depending on the make and model of the vehicle. It will say it fully meets the Mercon spec on the bottle. Unscrew and remove the plug. Pull the transmission dipstick, wipe it dry, push it in as far as it will go, pu … ll it out and see where it reads on the dipstick. There should be a 2-wire switch on top or near the top of the transfer case that turns on the 4x4 light. I attempted this and spent a day trying to get the level of fluid right.
Get the filter changed and get new fluid put in. Also, checking the level with the engine running allows for fluid to be circulating normally. It should be in the hash marked area at the bottom of the dip stick. Leave engine idling in Park with the break set and the wheels blocked. Consult your owner's manual for a schedule.
Make sure you use the correct fluid. Never fill it past the ï¿½Fullï¿½ mark. You can tell that you have this t … ype of transmission as it has no dipstick. If it still is not reading the correct level, add more fluid. Recommended Transmission Fluid for Ford Rangers Here is an example of a chart provided by the manufacturer of the Ford Ranger. It may answer your question.
Then use the dip-stick on the transmission fluid input. If you are having problems with the transmission in your Explorer, such as clunky shifting or hesitation, check the fluid level first - it is amazing how many drivers pay thousands of dollars for transmission work when a half quart of transmission fluid would have fixed the problem. The fluid will then begin to fall into the pan. The following instructions explain how to safely replace the transmission fluid in a Ford Explorer. Quickly take out and look at the level. Wipe the dip stick and re-incert into tube all the way till it stops.